Suzuki 4-Stroke 8HP Outboard Engine
(17 products)This page is for Suzuki 4-Stroke 8HP outboard engines. Use it to find compatible parts and basic service information. Below you’ll find maintenance tips, commonly replaced items, and troubleshooting guidance. You can also browse the main Suzuki collection for a wider selection. Scroll to the bottom of this page to start browsing parts for this engine, and on the collection page use the Filter & Sort controls to narrow results by horsepower, year range, and part category/section.
Browse All Suzuki PartsHow to Identify Your 8HP Model
- Locate the serial/nameplate on the transom bracket or swivel bracket. It lists the model, serial number, and shaft length.
- Read the model code: DF8A plus suffix letters for features (e.g., S = short shaft, L = long shaft, E = electric start, T = tiller, R = remote). Example: DF8AEL = DF8A, electric start, long shaft.
- Confirm 4-stroke identification: presence of an engine oil dipstick and oil filter on the powerhead.
- Platform clues: Many DF8A parts interchange with DF9.9A models; verify by model code and serial number before ordering.
Engine Overview
Suzuki DF8A 4‑Stroke Twin
| Feature | Description |
|---|---|
| Configuration | Inline 2-cylinder, carbureted 4‑stroke; manual or electric start; tiller or remote setup depending on suffix. |
| Common Models | DF8A, DF8AS/DF8AL (shaft length variants), DF8AEL (electric start long shaft). Often shares components with DF9.9A. |
| Advantages | Lightweight, quiet operation, strong low‑end torque, good fuel economy for small skiffs, tenders, and inflatables. |
| Notes | Match parts by model code, shaft length, and control type. Many routine service items are shared across the DF8A/DF9.9A family. |
Routine Maintenance & Service Parts
Intervals below are general guidelines for typical recreational use. Always follow the official Suzuki service manual for your exact model and environment.
| Item | Interval* | Remarks | Parts Link |
|---|---|---|---|
| Engine oil + filter | Every 100 hours or annually | Use FC‑W marine oil (e.g., 10W‑40) and the correct filter for DF8A. | Oil Filters |
| Gear oil (lower unit) | Every 100 hours or annually | Change and check for water intrusion. Replace seals if milkiness is found. | Suzuki Lower Unit Seal Kits |
| Spark plugs | Inspect 100 hours; replace 200 hours or as needed | Check gap and condition; replace if fouled or worn. | Suzuki Spark plug |
| Fuel filter / inline filter | Inspect every 50 hours; replace annually | Replace sooner if debris or fuel restriction is noted. | Suzuki Fuel filters |
| Water pump impeller / kit | Every 2–3 seasons or 200 hours | Replace sooner if the tell‑tale is weak or overheating occurs. | Suzuki Water Pump Repair Kits |
| Anodes (sacrificial) | Inspect every 50 hours; replace when 50% consumed | Choose zinc (salt), aluminum (brackish/salt), or magnesium (fresh) per your waters. | Suzuki Anodes |
| Propeller & hardware | Inspect every service; replace as needed | Check for dings, spun hub, correct pitch; verify cotter pin and thrust washer. | Suzuki Propellers |
| Thermostat & gasket | Inspect 200 hours; replace if overheating or stuck open/closed | Maintain proper operating temperature and warm‑up. | Suzuki Gaskets |
Frequently Used Parts Categories
- Routine Service: Suzuki Service & Maintenance Kits
- Cooling System: Suzuki Water Pump Repair Kits
- Fuel System: Suzuki Fuel filters
- Ignition / Electrical: Suzuki Rectifiers
- Propulsion: Suzuki Propellers
- Seals & Gaskets: Suzuki Gaskets
- Corrosion Protection: Suzuki Anodes
Common Symptoms & Quick Checks
| Symptom | Check First | Related Parts |
|---|---|---|
| Weak tell‑tale or overheat alarm | Inspect intake screens for blockage, verify strong tell‑tale at idle, confirm thermostat operation, and check impeller age. | Water pump kit, thermostat, intake screen/anodes |
| Hard starting or rough idle | Use fresh fuel, prime bulb firm, verify choke/enricher function, check plug condition and battery (if electric start). | Spark plugs, fuel filter, carburetor kit |
| Poor acceleration or power loss | Check prop for damage or incorrect pitch, ensure fuel tank vent is open, inspect fuel filter and lines for restriction. | Propeller, fuel filter, spark plugs |
| Gearcase noise or metal in gear oil | Verify gear oil level/condition; look for water intrusion. Inspect prop shaft seals and thrust washer orientation. | Lower unit seal kit, prop hardware, bearings |
FAQs
Are DF8A parts interchangeable with other years or the DF9.9A?
Many routine service parts (impellers, filters, plugs) are shared across DF8A and DF9.9A variants, but some items differ by year, shaft length, and control/start options. Always confirm using your exact model code and serial number.
When should I replace the water pump impeller?
As a preventative measure every 2–3 seasons (or about 200 hours). Replace sooner if the tell‑tale weakens, overheating occurs, or you frequently operate in sandy/silty water.
How often should I change lower unit gear oil?
Inspect at least once per season and replace every 100 hours or annually. If you find milky oil, replace seals before further operation.
What information helps confirm part compatibility?
Provide the full model code (e.g., DF8AEL), serial number, shaft length (S/L), start type (manual/electric), and control type (tiller/remote). Photos of the nameplate and the part needing replacement are also helpful.
Ready to find the parts you need? Browse the main Suzuki collection and narrow by horsepower, year, and model.
Shop Suzuki Outboard PartsIf you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.
- Most relevant
- Best selling
- Alphabetically, A-Z
- Alphabetically, Z-A
- Price, low to high
- Price, high to low
- Date, old to new
- Date, new to old
SeaSierra
Hydrofoil Stabilizer – Fits Outboard Motors 5-150 HP (Replaces SeaSierra FO2001, UanofCn FO2001)
Regular price $32.50Unit price