Welcome Aboard!

10% savings across all ranges sitewide for new customers · Terms apply

FLASHSALE26

OMC 4-Stroke 15HP Outboard Marine Parts

(3 products)

Designed for OMC 4-Stroke 15HP outboard engines, this page helps you find compatible replacement parts and practical service information. You’ll find maintenance intervals, common replacement categories, and troubleshooting tips below. You can also browse our main Johnson/Evinrude/OMC collection. Scroll to the bottom of this page to start browsing parts for this engine. On the collection pages, use the Filter & Sort controls to narrow results by horsepower, year range, and part category.

Browse All Johnson/Evinrude/OMC Parts

How to Identify Your 15HP Model

  • Find the model/serial tag on the top outer edge of the clamp bracket or on top of the swivel bracket (port or starboard).
  • Model code suffixes typically indicate shaft length (S/L/XL), starting method (R rope/E electric), and control/steering options; note all letters to confirm parts.
  • 4-stroke models are identified by an engine oil dipstick and filler cap on the powerhead; 2-strokes will not have a crankcase oil dipstick.
  • Record the full model and serial number before ordering; many components overlap with 9.9 HP 4-stroke variants, but verification is required.

Engine Overview

OMC 15 HP 4‑Stroke Platform

Feature Description
Configuration Compact inline twin-cylinder, carbureted 4-stroke with manual or electric start options.
Common Models Johnson/Evinrude 15 HP 4-stroke models; many share components with their 9.9 HP 4-stroke siblings. Confirm by model/serial.
Advantages Quiet operation, strong fuel economy, smooth mid‑range torque, and broad parts availability.
Notes Verify shaft length and start/controls when selecting propellers, ignition, and service kits. Year-to-year updates may change compatibility.

Routine Maintenance & Service Parts

Intervals below are general guidelines for typical recreational use. Always follow the specific procedures and schedules in your official service manual.

Item Interval* Remarks Parts Link
Engine oil & filter Every 100 hours or annually Warm engine before draining; replace crush washer if applicable; verify oil spec and capacity. Oil Filters
Gear oil (lower unit) Every 100 hours or annually Inspect for water intrusion (milky oil) and replace drain/vent gaskets; service seals if contamination is found. Lower Unit Seal Kits
Spark plugs Inspect 100 hours; replace 200 hours or 2 seasons Use correct heat range and gap; replace sooner if fouled or misfire occurs. Spark plug
Fuel filter / water-separating filter Inspect every 50 hours; replace annually Drain or replace if debris/water present; stabilize fuel for storage. Fuel Filters
Water pump impeller/kit Every 2–3 seasons or 200 hours Replace sooner if weak tell‑tale, overheat alarm, or sandy/silty use. Johnson/Evinrude/OMC Water Pump Repair Kits
Anodes (zincs) Inspect each 50 hours; replace when 50% depleted Choose material for your water (zinc, aluminum, or magnesium) and keep mounting surfaces clean. Johnson/Evinrude/OMC Anodes

Frequently Used Parts Categories

Common Symptoms & Quick Checks

Symptom Check First Related Parts
Weak tell‑tale stream / overheat alarm Inspect intake screens for blockage; verify impeller condition; confirm thermostat operation. Water pump repair kit, thermostat, intake screen, anodes
Poor acceleration / power loss Check for stale fuel or water in fuel; inspect fuel filter and spark plugs; verify prop condition/pitch. fuel filter, spark plugs, propeller
Hard starting / rough idle Confirm choke/enrichment function; check for vacuum leaks; inspect plugs and fuel quality. spark plugs, fuel filter, fuel/air hoses
Gearcase noise / metal flakes in gear oil Inspect oil for water intrusion; check prop shaft for fishing line; test seal integrity. lower unit seal kit, bearings

FAQs

Are parts interchangeable across different years or between 9.9 HP and 15 HP models?

Many 4-stroke 9.9 HP and 15 HP models share components, but ignition, carburetion, and gearcase details can vary by year and configuration. Always confirm with your exact model and serial before ordering.

When should I replace the water pump impeller?

Inspect annually and replace every 2–3 seasons (or ~200 hours). Replace sooner if the tell‑tale weakens, the engine overheats, or you frequently run in sandy or silty water.

How often should the lower unit gear oil be changed?

Change gear oil every 100 hours or annually. If the oil appears milky or contaminated, service seals and replace gaskets before further operation.

What information do I need to confirm part compatibility?

Provide the full model number, serial number, approximate year, shaft length (S/L/XL), and starting/controls (rope/electric, tiller/remote). Photos of the nameplate and the part needing replacement are helpful.

Ready to find parts by horsepower, year, and model? Start in our main Johnson/Evinrude/OMC collection and narrow with Filter & Sort for your OMC 4‑Stroke 15HP.

Browse Johnson/Evinrude/OMC Parts

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.
View as
Back to top

Compare /5