Selva 75-90HP 4-Stroke Outboard Marine Engine Parts

(1 products)

This page is for Selva 75–90HP 4‑Stroke outboard engines. Use it to find compatible parts and service information, with maintenance tips, common replacement items, and troubleshooting guidance. You can also browse our main parts collections. Scroll to the bottom of this page to start browsing parts for this engine, and on the collection pages use the Filter & Sort controls to narrow results by horsepower, year range, and part category.

Browse Service & Maintenance Kits

How to Identify Your 75–90HP Model

Locate the nameplate/serial sticker on the transom bracket or swivel bracket. It lists model code, serial number, and often shaft length.
Read the model code suffixes: S/L/XL typically indicate 15/20/25 inch shaft; T may indicate tiller; R or E may indicate remote/electric start. Year codes can be embedded in the model string.
These are 4‑stroke motors: look for an engine oil dipstick and filler cap, and an EFI label on the cowling or intake.
If similar 75 and 90HP models share the same platform, differences may be in ECU calibration, intake/exhaust, or gear ratio—verify by model code and serial.

Platform Overview

Inline‑4 EFI 4‑Stroke (75–90HP Class)

Feature	Description
Configuration	Inline‑4, EFI 4‑stroke outboard; SOHC/DOHC depending on year; freshwater cooling via raw‑water impeller pump.
Common Models	75HP and 90HP 4‑stroke variants with short/long/extra‑long shafts; tiller or remote control configurations.
Advantages	Good fuel economy and mid‑range torque; smooth idle; broad propeller compatibility for fishing and runabout hulls.
Notes	Service parts such as spark plugs, filters, anodes, and water‑pump kits are routine items. Verify parts by model code, serial, and shaft length.

Routine Maintenance & Service Parts

Intervals below are typical guidelines for 4‑stroke outboards operating in mixed conditions. Always follow your official Selva service manual for exact intervals and specifications.

Item	Interval*	Remarks	Parts Link
Engine oil & filter	100 hours or annually	Use FC‑W marine 4‑stroke oil and replace the spin‑on oil filter at each service.	Oil Filters
Gear oil (lower unit)	100 hours or annually	Inspect for water intrusion or metal flakes; replace seals if contamination is found.	Service & Maintenance Kits
Spark plugs	Inspect 100 hours; replace ~300 hours	Gap to spec; replace sooner if fouled or misfire occurs.	Spark Plugs
Fuel filter / water separator	100 hours or annually	Replace canister or inline element; drain water frequently in humid climates.	Fuel Filters
Water pump impeller / kit	2 seasons or ~200 hours	Replace more often in sandy/silty water or if tell‑tale is weak.	Water Pump Impeller Rebuild Kits
Anodes (sacrificial)	Inspect every 3 months; replace at ~50% wear	Choose zinc (salt), aluminum (brackish), or magnesium (freshwater) to suit your water type.	Anodes

Frequently Used Parts Categories

Routine Service Kits — Service & Maintenance Kits
Cooling System — Water Pump Impeller Rebuild Kits
Fuel System — Fuel Filters and Fuel Pumps
Ignition / Electrical — Electrical Items and Starters
Propulsion — Propellers and Propeller Guards
Corrosion Protection — Anodes
Sealing & Driveline — Lower Unit Seal Kits

Common Symptoms & Quick Checks

Symptom	Check First	Related Parts
Weak tell‑tale or overheat alarm	Inspect intake screens for debris, verify strong water stream, and check thermostat function.	Water pump kit, thermostat, intake screen, anodes
Poor acceleration or power loss	Check prop condition/pitch, replace fuel filter, inspect spark plugs and fuel quality.	Propeller, fuel filter, spark plugs, fuel pump
Hard starting / rough idle	Confirm battery charge and connections, inspect plugs, and look for air leaks in fuel lines.	Spark plugs, fuel filter, primer bulb/hose, starter
Gearcase noise or milky gear oil	Drain and inspect gear oil; check prop‑shaft seal for fishing line damage; pressure/vacuum test lower unit.	Lower unit seal kit, gear lube, prop hardware
Battery not charging	Load‑test battery; inspect rectifier/regulator connections and fuses.	Rectifier/regulator, wiring/fuse, battery

FAQs

Are parts interchangeable between different years or platforms?

Some items (spark plugs, anodes, common filters) often cross over, but many parts vary by model code, year, and shaft length. Always confirm with your exact model/serial information before ordering.

When should the water‑pump impeller be replaced?

As a rule of thumb, every 2 seasons or ~200 hours. Replace sooner if you see a weak tell‑tale, overheat warnings, or if the motor ingests sand or silt frequently.

How often should lower‑unit gear oil be changed?

Change at least annually or every 100 hours. If water or metal flakes are found, address seal or bearing issues before further use.

What information helps confirm part compatibility?

Provide the model code, serial number, shaft length, control type (tiller/remote), and any known year range. Photos of the nameplate and the part needing replacement are also helpful.

Ready to service your Selva 75–90HP 4‑Stroke? Browse our parts by category to match your horsepower, year, and model.

Shop Service & Maintenance Kits

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.