Welcome Aboard!

10% savings across all ranges sitewide for new customers · Terms apply

FLASHSALE26

Tohatsu 4-Stroke 75HP Outboard Marine Engine

(14 products)

This page is for Tohatsu 4-Stroke 75HP outboard engines. Use it to find compatible parts and service information, including maintenance tips, common replacement parts, and troubleshooting guidance. You can also browse the main Tohatsu collection. Scroll to the bottom of the page to start browsing parts for this engine, and remember that on the collection page you can use the Filter & Sort controls to narrow results by horsepower, year range, and part category.

Browse All Tohatsu Parts

How to Identify Your 75 HP Model

  • Nameplate/serial tag: Look on the transom bracket (usually starboard side) for the model code and serial number.
  • Reading Tohatsu codes: Example MFS75AETL = MFS (4‑stroke EFI), 75 (horsepower), A (series), E (electric start), T (power trim/tilt), L (20" shaft). Other suffixes may indicate 25" shaft (XL/UL) or rigging options.
  • Platform cues: A 4‑stroke inline‑4 with individual ignition coils and an oil filter on the powerhead. Remote-control models are most common on this horsepower.
  • Record details: Model code, serial number, shaft length (20"/25"), and control type (remote/tiller) help verify exact part fit.

Engine/Platform Overview

Tohatsu 75 HP Inline‑4 EFI 4‑Stroke (MFS75A family)

Feature Description
Configuration Inline‑4 SOHC, 16‑valve EFI 4‑stroke with performance‑tuned 4‑2‑1 exhaust and robust alternator output for onboard electronics.
Common Models MFS75A, MFS75AETL (20" shaft, remote, electric start). Exact suffixes vary by shaft length and rigging.
Advantages Strong mid‑range torque and acceleration, quiet operation, good fuel economy, and ample charging capacity for fishfinders and GPS.
Notes Follow 4‑stroke service practices (engine oil and filter). Some parts interchange across related horsepower variants in the same series; confirm by model code and serial. Match shaft length to transom height (20"/25").

Routine Maintenance & Service Parts

Intervals below are general guidelines for typical recreational use. Always follow the official service manual and adjust for local conditions and duty cycle.

Item Interval* Remarks Parts Link
Engine oil + filter 100 hours or annually Use FC‑W 4‑stroke marine oil; warm engine before draining for a complete change. Shop Oil Filters
Gear oil (lower unit) 100 hours or annually Inspect for water intrusion (milky oil) and metal fines; replace gaskets/crush washers. Service & Maintenance Kits
Spark plugs Inspect 100 hours; replace 300 hours (typical) Check gap and look for fouling or glazing; replace as a set. Spark Plugs
Fuel filter / water separator 100 hours or annually Drain or replace more often with ethanol fuels or if contamination is present. Fuel Filters
Water pump impeller/kit 2 seasons or 200 hours Replace sooner if stream is weak, overheats occur, or after sandy/silty use. Tohatsu Water Pump Repair Kits
Anodes (external and internal) Inspect every 50 hours; replace as needed Use the correct alloy for your water (salt/brackish/fresh). Replace when ~50% consumed. Anodes
Propeller & prop shaft seal check Each haul‑out or 100 hours Remove prop to clear fishing line; inspect seals and keyway; grease splines. Tohatsu Lower Unit Seal Kits

Frequently Used Parts Categories

Common Symptoms & Quick Checks

Symptom Check First Related Parts
Weak telltale stream / overheat alarm Inspect intake screens for debris, verify telltale hose is clear, and assess impeller condition. Water pump kit, thermostat, intake screen
Poor acceleration or loss of top speed Check prop condition/pitch, fuel quality, filters, and spark plugs; confirm engine height and trim. Propeller, fuel filter, spark plugs
Hard starting / rough idle Verify battery voltage and connections, ensure kill switch is set, prime fuel system, inspect plugs. Spark plugs, fuel filter, starter, sensors
Gearcase noise or metal in gear oil Check oil level/condition, look for water (milky oil), inspect prop shaft for fishing line and seal damage. Lower unit seal kit, crush washers, propeller
Low charging voltage to electronics Measure output at idle and cruise, inspect battery, grounds, and harness connectors. Rectifier/regulator, battery cables, fuses

FAQs

Are parts interchangeable across different years or related models?

Many service items (filters, anodes, some gaskets) may interchange within the same MFS75 A‑series family, but gearcase, rigging, and calibration parts can vary. Always confirm by full model code and serial number.

When should I replace the water pump impeller?

As a preventative measure, replace the impeller every 2 seasons or ~200 hours. Replace immediately if the telltale is weak, the engine overheats, or after sand/silt ingestion.

How often should I change lower unit gear oil?

At least annually or every 100 hours. Inspect for water intrusion (milky color) and metal particles. Replace crush washers and address leaking prop shaft seals as needed.

What information helps confirm part compatibility?

Provide the model code (e.g., MFS75AETL), serial number, shaft length, control type (remote/tiller), and photos of the nameplate and the part you need. This ensures we match the correct components.

Ready to find parts for your Tohatsu 75 HP? Browse the main Tohatsu collection by horsepower, year, and model.

Shop Tohatsu Outboard Parts

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.
View as
Back to top

Compare /5