Welcome Aboard!

10% savings across all ranges sitewide for new customers · Terms apply

FLASHSALE26

Volvo Penta 375HP 4-Stroke Marine Engine Parts

(4 products)

Designed for Volvo Penta 4‑Stroke 375 HP marine engines, this page helps you find compatible parts and key service information. Inside you’ll find maintenance tips, frequently replaced parts, and troubleshooting guidance. You can also browse the main Volvo Penta collection any time. Scroll to the bottom of this page to start browsing parts for this engine, and use the Filter & Sort controls on the collection page to narrow by horsepower, year range, and part category.

Browse All Volvo Penta Parts

How to Identify Your 375 HP Model

  • Locate the identification/serial plate on the engine. Common locations include the starboard rocker cover, front timing cover area, or a tag near the ECM; the drive unit has a separate tag on the upper gear housing or transom shield.
  • Read the full model code and suffix. Volvo Penta engine codes typically include the engine family (e.g., V8) and performance level; suffix letters can indicate emissions calibration, control type, or paired drive.
  • Confirm platform. 375 HP gas models are commonly V8 4‑stroke sterndrives. Some are based on larger 8.1 L “big‑block” architecture; others use 6.0–6.2 L V8 platforms. Platform differences affect ignition, cooling, and exhaust components.
  • Note the outdrive model (e.g., DP‑S/DP‑H Duoprop). Drive model and ratio influence propeller selection, anodes, bellows, and seal kits.

Platform Overview

V8 8.1 L (Gasoline Sterndrive ~375 HP)

Feature Description
Configuration V8 gasoline, multi‑port fuel injection, raw‑water cooled seawater pump feeding heat exchanger or direct cooling depending on installation.
Common Models V8 8.1 L variants around 375 HP; paired with DP‑S/DP‑H Duoprop drives in many installations.
Advantages Strong torque for heavier hulls; robust cooling hardware; proven sterndrive pairing.
Notes Impeller and exhaust components differ from later 6.0–6.2 L platforms; confirm model/serial before ordering gaskets, risers, and sensors.

V8 6.0–6.2 L (Gasoline Sterndrive ~375–380 HP)

Feature Description
Configuration V8 gasoline, EFI/ECM controlled, serpentine drive; matched to modern DPS/DPH drive families.
Common Models V8 6.0–6.2 L calibrations near 375–380 HP; common in newer sterndrive packages.
Advantages Improved fuel efficiency, ECM diagnostics, and accessory layout; broad prop options for Duoprop drives.
Notes Belts, sensors, and some cooling parts are platform‑specific; verify engine tag and drive model for exact fit.

Routine Maintenance & Service Parts

Intervals below are general guidelines for gasoline 4‑stroke sterndrives; always follow the official Volvo Penta service schedule for your exact model and operating conditions.

Item Interval* Remarks Parts Link
Engine oil & filter 100 hours or annually Change more often in harsh duty or high idle time. Warm engine before draining. Volvo Penta Oil Filters
Gear oil (outdrive) 100 hours or annually Inspect for water intrusion/metal. Replace seals if contamination is found. Volvo Penta Lower Unit Seal Kits
Spark plugs 200 hours or 2 years Check gap and condition; fouling points to fuel/ignition issues. Spark Plug
Fuel filter / water separator 100 hours or seasonally Replace sooner if water or debris is present; carry a spare cartridge onboard. Volvo Penta Fuel filters
Raw‑water pump impeller 100 hours or every 1–2 seasons Replace proactively; heat and dry‑running damage vanes quickly. Volvo Penta Water Pump Repair Kits
Anodes (drive/engine) Inspect 50 hours; replace when 50% consumed Use the correct anode material for your water (zinc, aluminum, or magnesium). Volvo Penta Anodes
Serpentine/drive belt Inspect 100 hours; replace ~300 hours or as needed Look for cracking, glazing, or squeal under load. Belts

Frequently Used Parts Categories

Common Symptoms & Quick Checks

Symptom Check First Related Parts
Overheat alarm at idle or weak cooling flow Inspect seawater intake screens/strainer, belt tension, impeller condition, and thermostat function. Water pump repair kit/impeller, thermostat, intake screen/anodes, belt
Poor acceleration or power loss Check propeller damage or fouling, fuel filter contamination, and spark plug condition. Propeller, fuel filter, spark plugs, ignition components
Hard starting / rough idle Verify battery voltage and cable connections; inspect starter engagement; check for vacuum leaks and dirty throttle body/IAC. Starter, ignition switch, fuel filter, gaskets/hoses
Gearcase noise or metal in gear oil Check gear oil level/condition, prop‑shaft fishing line, and seal integrity. Lower unit seal kit, prop hardware, bearings

FAQs

Are parts interchangeable between different years or between the 8.1 L and 6.0–6.2 L V8 platforms?

Some service items overlap, but many cooling, ignition, and exhaust parts are platform‑specific. Always verify the engine model/serial and drive model to ensure correct fit.

When should I replace the raw‑water pump impeller?

As a preventative measure every 100 hours or 1–2 seasons. Replace immediately if there was any dry‑running, overheating, or if vanes show cracking or set.

How often should I change the outdrive gear oil?

Typically every 100 hours or annually, and any time water intrusion or metallic debris is found. After a seal replacement, recheck level and condition after the first few hours.

What information do you need to confirm part compatibility?

Engine model designation, serial number, drive model/ratio, and a brief description or photos of the existing part. This ensures the correct impeller kit, gaskets, sensors, and propeller hardware.

Ready to find parts for your Volvo Penta 375 HP engine? Browse the main Volvo Penta collection and use the filters to narrow by horsepower, year, and category.

Shop Volvo Penta Parts

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.
View as
Back to top

Compare /5