Welcome Aboard!

10% savings across all ranges sitewide for new customers · Terms apply

FLASHSALE26

Volvo Penta 4-Stroke 124HP Marine Engine Parts

(1 products)

This page is for Volvo Penta 4-Stroke 124HP outboard engines. Use it to find compatible parts and service information, including maintenance tips, common replacement items, and troubleshooting guidance. You can also browse the main Volvo Penta collection. Scroll to the bottom of the page to start browsing parts for this engine. On the collection page, use the Filter & Sort controls to narrow results by horsepower, year range, and part category.

Browse All Volvo Penta Parts

How to Identify Your 124HP Model

  • Nameplate/serial plate location: typically on the transom bracket or swivel bracket; a secondary sticker may be on the powerhead cover. Record the full model designation and serial number.
  • Model code and suffix: suffixes often indicate shaft length (S/L/XL), control type (tiller vs. remote), and regional or emissions variants. The serial number is the most reliable key for parts matching.
  • 4‑Stroke specifics: confirm it is a 4‑Stroke (has an engine oil dipstick and oil filter). Note if it uses EFI and any visible fuel/water-separating filter.
  • Gearcase/shaft options: verify shaft length and gearcase style before ordering props, seals, and water pump kits.

Platform Overview

Inline‑4 EFI 4‑Stroke (Approx. 124 HP class)

Feature Description
Configuration Inline‑4, EFI 4‑Stroke outboard; designed for balanced torque, quiet operation, and efficient fuel use.
Common Models 124HP EFI 4‑Stroke variants in S/L/XL shaft lengths with remote or tiller control. Use your serial number to confirm exact fitment.
Advantages Good mid‑range torque, fuel economy, and low noise; EFI provides smooth starting and steady idle.
Notes Genuine Volvo Penta parts are built to tight tolerances and validated for compatibility. Anodes, propellers, and water pump parts should match your specific drive and shaft length.

Routine Maintenance & Service Parts

Intervals below are general guidelines for 4‑Stroke outboards. Always follow the procedures and schedules in your official service manual.

Item Interval* Remarks Parts Link
Engine oil + filter Every 100 hours or annually Use marine‑rated 4‑Stroke oil; replace filter and sealing washer as applicable. Volvo Penta Service & Maintenance Kits
Gear oil (lower unit) Every 100 hours or annually Change sooner if water intrusion or metal present; renew drain screw seals. Volvo Penta Lower Unit Seal Kits
Spark plugs Inspect 100 hrs; replace 200 hrs or as needed Verify correct heat range and gap for your serial range. Spark Plugs
Fuel filter / water separator Inspect 50 hrs; replace 100 hrs Drain water as needed; replace more often with poor fuel quality. Volvo Penta Fuel Filters
Water pump impeller/kit Inspect annually; replace ~2 seasons or 200 hrs Replace sooner after sand/silt ingestion, overheat, or low tell‑tale flow. Volvo Penta Water Pump Repair Kits
Anodes (zinc/aluminum/magnesium) Inspect 50–100 hrs; replace at ~50% depletion Match alloy to water type (salt, brackish, fresh) for effective corrosion protection. Volvo Penta Anodes
Air filter (if equipped) Inspect 100 hrs; replace as needed Keep intake clear for proper idle and acceleration. Volvo Penta Air Filters

*Intervals are typical recommendations; always follow the maintenance schedule for your exact model and serial number.

Frequently Used Parts Categories

Common Symptoms & Quick Checks

Symptom Check First Related Parts
Weak tell‑tale or overheat alarm Inspect water intake screens for debris; verify tell‑tale is clear; assess impeller and housing; test thermostat. Water pump repair kit, thermostat, intake screen, anodes
Poor acceleration or power loss Check prop condition/pitch, fuel quality, fuel filter restriction, and spark plug fouling; verify throttle opening and compression. Propeller, fuel filter, spark plugs
Hard starting or rough idle Confirm battery voltage and connections; prime fuel system; inspect plugs; check for vacuum leaks and a dirty air filter. Spark plugs, fuel filter, air filter, starter
Gearcase noise or metal in gear oil Verify gear oil level/condition; inspect drain plug seals; check for fishing line on prop shaft; confirm correct shift adjustment. Lower unit seal kit, bearings, gear set, prop shaft seal
Low charging voltage Load‑test battery; clean/tighten grounds; check rectifier/regulator and alternator output to spec. Alternator, rectifier/regulator, battery cables

FAQs

Are parts interchangeable between different years or platforms?

Not always. Model year changes, shaft length, gearcase type, and EFI updates can affect parts fit. Use your full model and serial number to confirm compatibility before ordering.

When should the impeller be replaced?

Inspect annually and replace about every two seasons or 200 hours. Replace sooner if you operate in sandy/silty water, see weak tell‑tale flow, or experienced an overheat.

How often should the gear oil be changed?

Typically every 100 hours or once per season. If the oil looks milky, smells burned, or contains metal, service immediately and inspect seals and bearings.

What information do you need to confirm part compatibility?

Provide the model designation, serial number, shaft length (S/L/XL), control type (tiller/remote), and photos of the nameplate and the part you’re replacing. This ensures the correct match for your 124HP 4‑Stroke.

Ready to find parts by horsepower, year, and model? Browse our main Volvo Penta collection to locate parts that fit your engine.

Shop Volvo Penta Parts

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.
View as
Back to top

Compare /5