Volvo Penta 4-Stroke 240HP Marine Engine Parts

(6 products)

This page is for Volvo Penta 4-Stroke 240HP outboard engines. It helps you find compatible parts and service information, including maintenance tips, common replacement parts, and troubleshooting guidance. You can also browse the main Volvo Penta collection. Scroll to the bottom of the page to start browsing parts for this engine, and remember that on the collection page you can use the “Filter & Sort” controls to narrow results by horsepower, year range, and part category.

Browse All Volvo Penta Parts

How to Identify Your 240HP Model

Find the serial/nameplate on the mounting bracket or swivel bracket; a duplicate ID label may appear under the engine cowling.
Model codes often include shaft length (L/XL), control/trim options, and a year/series suffix. Note all letters and numbers.
For 4-stroke EFI engines, look for emissions and EFI labels; these help confirm the specific generation and electronics package.
Photograph the nameplate and any control module labels if you need help verifying parts compatibility.

Engine Overview

Volvo Penta 240HP 4‑Stroke Platform

Feature	Description
Configuration	V6, 4‑stroke gasoline, EFI with electronic engine control
Common Models	Examples include V6‑240 family variants; specifics vary by year, shaft length, and control options
Advantages	Strong mid‑range torque, smooth operation, and EFI efficiency
Notes	Routine service focuses on oil & filter, raw‑water impeller, anodes, fuel filtration, and gearcase maintenance. Verify electronics (sensors/ECU) by serial to ensure correct replacements.

Routine Maintenance & Service Parts

Intervals below are general guidelines for 4‑stroke marine use. Always follow the official service manual and adjust for heavy use, sandy/silty water, or long storage.

Item	Interval*	Remarks	Parts Link
Engine oil & filter	Every 100 hours or annually	Warm engine before draining; replace crush washer as needed	Oil Filters
Gear oil (lower unit)	Every 100 hours or annually	Inspect for water intrusion and metal fines; replace drain plug gaskets	Volvo Penta Lower Unit Seal Kits
Spark plugs	Inspect 100 hours; replace 200–300 hours or as needed	Use correct heat range and gap; replace coils/boots if cracked	Spark Plugs
Fuel filter / water separator	Every 100 hours or each season	Replace sooner if water or debris is found	Volvo Penta Fuel Filters
Water pump impeller / kit	200 hours or every 2 seasons (sooner in sandy water)	Critical for cooling; replace housing/plate if scored	Volvo Penta Water Pump Repair Kits
Anodes (corrosion protection)	Inspect every 50 hours; replace when 50% consumed	Choose zinc (salt), aluminum (brackish), or magnesium (fresh)	Volvo Penta Anodes
Serpentine/drive belt	Inspect every 100 hours; replace 300–400 hours or if cracked	Check tensioner and idlers; listen for bearing noise	Belt

Frequently Used Parts Categories

Routine Service Kits – Volvo Penta Service & Maintenance Kits
Cooling System (pumps/impellers) – Volvo Penta Water pumps
Fuel System – Volvo Penta Fuel filters
Ignition / Sensors – Sensors
Propellers – Volvo Penta Propellers
Corrosion Protection – Volvo Penta Anodes
Gaskets & Sealing – Volvo Penta Gaskets

Common Symptoms & Quick Checks

Symptom	Check First	Related Parts
Weak tell‑tale stream or overheat alarm	Inspect intake screen and water pump impeller; verify thermostat operation	Water pump repair kit, impeller, thermostat, intake screen
Poor acceleration or power loss	Replace fuel/water separator, check spark plugs, scan for sensor faults	Fuel filter, spark plugs, air intake components, MAP/O2 sensors
Hard starting or rough idle	Verify battery voltage, check plugs and coil boots, look for air leaks	Spark plugs, ignition coils, fuel filter, sensors, starter
Gearcase noise or metal in gear oil	Change gear oil and inspect magnet; pressure test and reseal if needed	Lower unit seal kit, drain plug gaskets, bearings

FAQs

Are parts interchangeable between different years or platforms?

Some service parts carry over, but many items (sensors, electronics, brackets) are year/serial specific. Always confirm by serial number and model code before ordering.

When should the impeller be replaced?

As a rule, every 200 hours or every two seasons—sooner if you run in sandy or silty water, see weak water flow, or find vane cracks during inspection.

How often should gear oil be changed?

Every 100 hours or annually. If you see water contamination (milky oil) or metal on the drain plug magnet, service immediately and pressure test the gearcase.

What information do you need to confirm part compatibility?

The engine brand, full model code, serial number, horsepower, and any control/electronics details. Photos of the nameplate and the part to be replaced are also helpful.

Ready to find the right parts? Browse the main Volvo Penta collection and filter by horsepower, year, and model to pinpoint compatible components.

Shop Volvo Penta Parts

If you’re unsure about your model, send us a photo of the nameplate and the part you need and we’ll help verify compatibility.